GSM WIFI LBS Heavy Equipment Gps Tracking Devices

Magnetic Equipment Gps Tracker 2G GSM GPRS Non-Powered Tracking For Asset

4.1.1 Position and Monitor

The default setting is the terminal would send one packet each 24 hours, the packet information includes: Position status, longitude and latitude, GSM Signal Strength, GPS numbers, battery voltage etc, the upload interval can be configured

4.1.2 AGPS

The terminal is with APGS function, when the terminal connects GPRS, AGPS can be used to speed the position speed and improve the position accuracy

4.1.3 LBS

The default position mode is by GPS, when GPS enters into the blind zone and cannot position accurately, the terminal will switch to LBS, LBS provides the reference location which is not very accurate

4.1.4 WIFI Position

The terminal is with built in WIFI Chip, when it starts, the WIFI Chip will automatically connects to the WIFI hotspot nearby and filter the hotspot info then select the WIFI hotspots with strongest signal, the terminal will pack those hotspots info and saved into the pack that will be uploaded, after the backend receives information from the terminal, it will interpret the WIFI info and acquire the current location info according to the WIFI position server.

The default setting is WIFI priority, once it detects WIFI Hotspot, it will upload WIFI info only , and do not use GPS, if WIFI is not detected, it will use GPS to position

4.1.5 Intelligent Tracking Function

When found the vehicle is stolen or in other emergency cases and the real time location of the vehicle needs to be checked, a SMS can be sent or send a command from the backend, when the terminal starts work next time, it will receive this command and enter into track mode, and upload the location data according to the preconfigured interval by customer until a stop tracking command is received

4.1.6 Blind Zone Compensation

When the terminal enter into blind zone when in sleep mode,it will store the trace data according to the preconfigured time interval and it will upload the data in the blind zone to the backend

Remark: MT07/MT07C upload 16-32 pack blind zone compensation data, MT07W/MT07CW uploads 8-16 pack blind zone compensation data.

4.1.7 Clock Mode

The terminal could verify the timely wake up time points, maximum 4 points can be set for more accurate position and connection to the server, this function could use SMS command or backend command to set

4.1.8 Backend Specific Commands

Since the working time of the terminal is short, it is rare to receive the SMS, to ensure the command sending efficiently, the backend uses a specific commands for MT06CW which can preset the command, when the terminal is online, the backend will automatic send this command, to make sure the commands is properly received.

4.1.9 Battery Level Detect

The terminal will upload the battery level status together with the location data pack, and display the battery level on the backend so the user could well know the balance battery, and meanwhile display the current transmission time and the balance battery level of the next uploading pack, so the user could have clear view on the terminal status

4.1.10 Light Sensor Detect

At Bottom of MT07/MT07W is built in with high sensitive light sensor, when the terminal is tampered, the terminal will be activated even in sleep mode and enter into tamper alarm working mode, and upload the alarm function to the backend

4.2 Function List

GSM Heavy Equipment Gps Tracking Devices

2G Heavy Equipment Gps Tracking Devices

GSM commercial truck tracking devices

GSM WIFI LBS Heavy Equipment Gps Tracking Devices Images